 |
 |
Grass King Offset Flail Mowers
 |
|
|
An adjustable CAT I or CAT II hitch allows the Grass King to fit tractors from 50 to 90 HP. The adjustment permits the flail to be positioned to cut outside the rear tractor tire. Tractor must have a 540 RPM PTO, single remote hydraulic connection, and three-point hitch. Note: Remote hydraulic connection and three-point hitch must work at the same time. A four-bar folding linkage allows the single hydraulic cylinder to position the flail mower from 45° down for ditch bank trimming through 90° up for transport. The Grass King uses the time-tested flail mowing system and proven piston pump and motor of the reliable Alamo Industrial (Mott) Interstater, which has been mowing governmental grounds for over 20 years. |
Specifications
|
A-FRAME - The frame is a full-floating, adjustable, CAT I of II, that allows offset mounting to the right rear. CUTTING HEAD - Wide swath cutting width of 62" and 74" are offered. Cutting heights may be adjusted, in ½" increments, from 0" to 6". The cutter housing is made of sturdy, unitized, 10 gauge steel. The inboard end-plate is made of ½" thick steel and the outboard end-plate is made of 5/16" thick steel. SKID SHOES - The head has full-length, rounded skid shoes that are replaceable. CUTTER SHAFT - The cutter shaft is 4½" OD and balanced. It has four rows of 3 oz. reversible knives. Power is delivered through two "B" sections belts with automatic tension adjustment. The bearings are 1-15/16", greaseable and self-aligning.
FLAIL KNIVES - 62" Wide swath has 76 fine-cut pairs or 36 coarse-cut pairs. REAR ROLLER - The Grass King has a full-width roller that is greaseable with self-aligning bearings and end caps for added protection. SAFETY SHIELD - A full-width rubber deflector is mounted on the rear of the cutting head. HYDRAULIC DRIVE SYSTEM - The piston pump and motor are rated at 30 GPM and 4000 PSI at 540 PTO RPM. An automatic relief valve protects the system from overload. A 14-gallon hydraulic oil reservoir is used while the entire hydraulic system uses 19-gallons of hydraulic oil. Four-wire braid is used on the hoses to give them a 16,000 PSI burst pressure. TAIL WHEEL - A 20-ply tire is used for the tail wheel which is full-swiveling and supports most of units weight, allowing the Grass King to be used on smaller tractors.
APPROXIMATE WEIGHT - Complete with 62" flail head - 1720 lbs.
OTHER OPTIONAL EQUIPMENT - Check chains: Relieves three-point hitch. |
*Note: A.B.C. Groff is an equipment dealer. We are NOT the Manufacturer.
| Industrial Main Page | ||||